Difference between revisions of "Speedtouch 780 Tips"
From Briki
(→Useful CLI commands) |
|||
| Line 15: | Line 15: | ||
; dns server host add name=myhost addr=myip | ; dns server host add name=myhost addr=myip | ||
: Add DNS name '''myhost''' for device with IP address '''myip''' | : Add DNS name '''myhost''' for device with IP address '''myip''' | ||
| + | |||
| + | ; ip config natloopback=enabled | ||
| + | : Enable NAT loopback (to allow you to use the WAN IP address/hostname from inside the LAN) | ||
; saveall | ; saveall | ||
: Make setting persistent between reboots | : Make setting persistent between reboots | ||
Revision as of 11:20, 1 October 2006
Useful CLI commands
- env set var=SESSIONTIMEOUT value=900
- Set telnet session timeout to 15 mins
- dns server config domain=mydomain.org
- Configure domain name for LAN
- eth bridge ifdetach intf=ethport4
eth bridge vlan ifdelete name=video_gr intf=ethport4
eth bridge ifattach intf=ethport4 - Enable 4th ethernet port (middle step seemed unnecessary for me, but is recommended)
- dns server host add name=router
- Add DNS name router for Speedtouch device
- dns server host add name=myhost addr=myip
- Add DNS name myhost for device with IP address myip
- ip config natloopback=enabled
- Enable NAT loopback (to allow you to use the WAN IP address/hostname from inside the LAN)
- saveall
- Make setting persistent between reboots
